Beretta PX4 Assembled Safety Lever Type "92FS R.P." Reviews

I loved they way these levers looked; however, the hole for the roll pin was slightly oversized. The levers didn't work properly and would bind. I've installed the Decocker Carry Levers on other Px4's with no issues, but these were difficult. I re-installed the factory levers. Very disappointing as every part I've ordered from Beretta for my Px4 or 92's worked flawlessly until now.

Good deal, get this to get rid if the sharp stock safety.

Installed these to replace the sharp, protruding stock safety/decocker levers on my two PX4 .. installation was fairly easy as I followed a YouTube video (link below) .. i found it easier and less likely to damage the roll pin securing lever if a another person assist by holding lever in the precise position to align hole 1i while driving out/in roll pin with punch ... i'll admit, these do look and feel better than stock, but I was expecting a bit more smaller in size... Overall, happy with purchase.... https://youtu.be/GWc6i506oEQ

You are definitely going to want these to save wear and wear on your hands from the sharp stock levers. I noticed the 9mm version has a lighter recoil spring so stock isn't so bad. Heavier calibers this is a must have. Might as well do the G series conversion while you're at it.

I REALLY wanted these and for them to work. I'm 92 fan and wanted the same safeties on my new to me Full Size, PX4 .40 S&W. Tried for hours to get them installed, but to no avail. The little arm part the extends from one of the safety levers, the side with circular spring is the wrong dimension for my pistol. That little protruding wing or whatever it is would not allow me to push the roll pins in correctly. Had other issues, but that was the biggest. I uninstalled factory safety, tried to install this version over and over, reinstalled factory safeties, uninstalled them again, tried to install these new safeties and still no go. Gave up after a couple hours and put the old ones back on. Not happy w/the old ones, the hurt my thumb and index finger when racking slide with sharp pointy edges. Oh well, still enjoy the PX4. Hopefully, I can get my money back and buy other accessories.